But its this type of complacency and lack of safety awareness which can cause serious injuries and even deaths. Water is the number one enemy of wood.
A face break results in a dangerous loss of strength.
What is the most dangerous hazard in using scaffold planks. Where it is impractical for workers to climb down and the scaffold is over 3 m 10 ft in height each worker must be tied off with a full body harness and lanyard. Employees using scaffold devices shall be trained and use safe work practices. Storms and High Winds Working on a scaffold is prohibited during storms or high winds unless a competent person has determined that it is safe to be on the scaffold and workers are protected by personal fall- arrest systems or wind screens.
Planks showing face breaks must be removed from service. Wooden planks seem to lie at the heart of most residential scaffold failures. The wooden planks also soak up moisture while the aluminum versions often pool the rainwater creating a dangerous slipping condition.
The collapse of a scaffold can cause death or significant injury to workers or passers-by and damage structures. Moving a rolling scaffold while workers are still on the platform can be a very dangerous practice and can cause workers to fall or slip especially if the working platforms are already insufficient andor if any of the planks are loose or loaded down too heavily. This document provides an introduction to some of the requirements intended to prevent scaffold related injuries.
A primary objective of scaffold planning and design is to prevent scaffold collapse before during and after placement of the scaffold. Protecting these workers from scaffold-related accidents would prevent an estimated 4500 injuries and 50 fatalities each year. Your workers can comfortably rely on LVL Scaffold boards for optimal safety and performance.
A real hazard if the boards are wet and especially if iced. According to OSHA injuries related to scaffolds include falls tip-overs being struck by falling equipment and coming into contact with energized power lines. Definitions Competent Person – One who is capable of identifying existing and predictable hazards in the surroundings or working conditions which are unsanitary hazardous or dangerous to employees and who has authorization to take prompt corrective.
What should not be used to support a scaffold. One of the major dangers of scaffolding is that workers on site become complacent working on and around it. Building scaffolding for work projects can present numerous serious hazards to employees.
Shipyard work has traditionally been hazardous with an injury-accident rate more than twice that of construction and general. About 65 of all construction workers use scaffolding in their daily work. The following case demonstrates a violation frequently seen when workers use a scaffold.
And for good reason scaffolding is a central part and mainstay on almost all sites – so people get used to it. The most important part of any guide to scaffold inspection is emphasizing that it be performed by a competent person. But the blame goes to workers unfamiliar with safe and proper use of equipment.
Helps workers identify and control the hazards that cause the most serious scaffold-related injuries. OSHA defines a competent person as one who is capable of identifying existing and predictable hazards in the surroundings or working conditions which are unsanitary hazardous or dangerous to employees and who has. In fact some experts claim plank failures cause injury in 90 of the cases they investigate.
Scaffolding Safety Tips for the Winter Months Ahead Winter is one of the most dangerous times of year for construction workers. Lifelines must be attached to a suitable anchor point other than the scaffold. Plank Damage and its Many Forms Like all wood and plant fiber products scaffold plank is subject to decay and damage.
32205 Little Mack Avenue Roseville MI. Rapid weather changes low temperatures falling snow and ice represent just a small sampling of the problems construction workers face on the job each and every day. Top of the plank.
A crew was working on a scaffold applying stucco to a six-story college dormitory. The most common hazard on scaffolding is the potential for falling. While it may seem careless for anyone to fall through the 16 or so gap between the walk boards and the lower knee board it becomes a very real possibility at 70 on the shaded side of the building.
Moving rolling scaffolds with workers on the platform can be dangerous. Gouges depressionsAreas of plank where wood fiber has been torn away. Some workers prefer the use of the planks since the aluminum platforms are often slick and tend to slide on the steel tubing of the scaffold sections.
Thats quite obvious since the purpose of erecting scaffolds is to provide a safe place to work when you must work at a height above ground level. Knots and cross grain show up like a bad penny in most failures. The most common accident involving scaffolds at construction sites is a fall to a lower level.
Boards that do not dry properly are at risk of rot. An employee on the fifth floor stepped on a guardrail to access the next level of the scaffold.